Inductive water proof hour meter for marine red ATV Motorcycle Dirt bike MX SKI13.50

Features:

1. Waterproof design

2. Built-in battery power supply, safe and reliable

3. Sensor design, simply tied onto the plug cable can operate

4. Track the service life of your vehicle-oil changes, valve, adjustments, plugs, etc.

5. Easy installation-peel & stick, no wiring necessary, or attach with enclosed hardware

6. Works on any gas engine

7. Records and displays to 9,999.9 hours.

8. Hour glass symbol appears and flashes on / off to indicate counting time.

9. Automatic roll over

10. 1.0inch LCD screen display

11. Waterproof material

Specification:

Resolution: 0.1 hour

Type: Electronic Gadgets

Temperature: -30 Degree ~ 85 Degree

Dimensions: 2.13 in 1.46 in 0.59 in (5.4cm 3.7cm 1.5cm)

Compatibility: All motorcycle models

Hardware Included: Meter, pick-up wire, two screws?Tools required: 2.Smm socket to remove shroud, wire cutters.

Installation:

1.Wrap the included pick-up wire around the plug wire five times. Start wrapping the Pick-up wire about 4cm from the end of plug boot. Use the included zip tie to secure the pick-up wire wrapping as shown in the photo right.

2.Before continuing the installation, insert the pick-up wire into the rear of the meter. Start the motor to make sure the meter is picking up the ignition signal. If it is, this will activate the timer on the meter and the icon on the left of the LCD will flash. You will have to wait at least 6 minutes to increase the timer display. If it is not picking up the ignition signal, slide the pick-up wrap closer to the for plug boot.

3.1f the meter is successfully picking up the spark signal, run and zip tie the pick-up along one of the throttle cables. Make sure the pick-up wire cannot make contact with the engine. Also, make sure you leave enough (about 8cm) so removing the plug wire is possible. Keep in mind the

general location of final mounting location on the frame spare.

4.Securing Method:

a. Drilling into your frame with 2.5mm socket, then secure it to the frame coming with two pick-up screws.

b. using padded double-sided tape on the backside of the meter and secured it to the frame spar with zip ties.

That's all there is to the installation. Now you're set to accurately track your maintenance. Don?t forget to record the metered time when performing maintenance.

Packing Included:

1 Hour meter

1 Cable (110cm)

2 Screws